Bucket elevator for vertical lifting through the limestone crusher, coal, gypsum, clinker, clay and other dry granular materials and raw materials, cement, coal powder and other materials. Depending on the speed of the speed hopper, bucket elevator can be divided into: three forms of centrifugal discharge, discharge and gravity discharging mixed. Centrifugal discharge faster production speed of the bucket bucket elevator for conveying powder, granular, small block, such as small abrasive materials; gravity discharge of the slow speed bucket for bulk transport of larger proportion of large abrasive materials, such as limestone, clinker and so on. Bucket elevator traction components have chain, plate chain and tape several. Structure and manufacturing chain is relatively simple, and the hopper is also very strong, large transport abrasive materials, the chain wear small, but its larger self. Plate chain structure is strong, light weight bucket elevator manufacturers for lifting capacity of the hoist, but hinged joints susceptible to wear, tape is relatively simple, but not suitable for conveying abrasive materials large bucket elevator machine, plastic materials, temperature does not exceed 60 ° C, steel belt clip allows the material temperature reached 80 ° C, heat-resistant plastic material to allow the temperature reached 120 ° C, chain, plate chain conveyor material temperature up to 250 ° C . A bucket elevator installation, install the hoist should be fixed first base bucket elevator, base should be fixed on the basis of reliable, then connect to the machine base barrel turn, finally connecting the nose and install gearmotor. 2, after the whole installation straightening barrel in place across the floor and the floor must be fixed, if the attachments should install bearing housing bracket to prevent the whole machine tilt and shift 3, barrel connection allows the pad into the gasket in order to ensure sealing. 4, the hoist is installed as required hopper hopper belt, hopper with a good hopper were placed at both ends of the nose. Bypassing the first round and bottom round, early operational hole to connect. When the device hopper with. Should be raised to the highest position of the bottom wheel. 5, the correction to the level of the first axle, and the first axle and the axle is located within a unified vertical tail plane. 6, bucket elevator for vertical transportation equipment, first round, bottom round, the centerline of the barrel should be sought in the same vertical line, the deviation per meter length of not more than 2 mm, the accumulation of deviation is not more than 8 mm. 7, hopper mounted on the elevator, there should be no deviation caused by the housing crash occurred. 8, the hopper belt tensioning device should ensure a uniform normal work necessary tension. After nine, when the hoist is installed, each should be filled with oil lubrication, no-load test, load test normal load before commissioning and production efficiency bucket elevator, bucket elevator, Qingdao Xudong power equipment provided by the Qingdao Power Equipment Co., Ltd. Xudong. Power Equipment Co., Ltd. Qingdao Xudong (www.qdxudong.com) in the field of special equipment industry devoted boundless enthusiasm and passion, Qingdao Xudong electrical equipment has been customer-centric, for customers to create the concept of value, quality, service to win market, and sincerely hope to cooperate with the community to create success, create brilliant. Welcome to the relevant business information, contact: Mr. Liu.