Installation, use and maintenance 1, GDGS type slag machine with a running wheel, mounted on a fixed track, and to be fixed by the feet, which can meet the requirements of different users working conditions, specific installation dimensions refer to the accompanying drawings. 2, for the long-term normal continuous operation slag crusher Shandong single roller slag crusher, reducing downtime and failure to produce solid, and play the maximum efficiency of the machine, must be prepared to use operation and maintenance personnel should do the following: 2.1 Commissioning should note that the bolts fastening, found loose immediately tightened. 2.2 Before starting single roll crushers crushers, and not to the presence of the body has a lot of ash, after only normal operation, in order to gradually increase the amount of slag, so as not to cause a failure to start operation process 2.3 If abnormal, should immediately check the slag The hardness is normal feed particle size is in compliance with regulations. 2.4 When the safety pin when overload cut, it should be replaced at the same time to find out the cause of the overload to be eliminated. 2.5 regularly check out the situation spout found should immediately eliminate clogging. 2.6 Always check the degree of wear and timely replacement of worn parts. 2.7 at any time to observe and control instruments to prevent slag crusher produced a load. Should be kept within 2.8 bearings and gearbox have a sufficient amount of lubricating oil, without leakage. 2.9 should pay attention to the bearing operating temperature must not exceed 90 ℃. Operating personnel should do the following: 2.1 Commissioning should pay attention to the bolts fastening, found loose immediately tightened. 2.2 The slag machine starts, and not the presence of the body has a lot of ash Qingdao single roll crushers, after only functioning normally, in order to gradually increase the amount of slag in order to avoid failure during operation 2.3 If abnormal, should immediately check on startup whether normal hardness slag feed particle size is in compliance with regulations. 2.4 When the safety pin when overload cut, it should be replaced at the same time to find out the cause of the overload to be eliminated. 2.5 regularly check spout case of single roll crushers companies should be found immediately eliminate clogging. 2.6 Always check the degree of wear and timely replacement of worn parts. 2.7 at any time to observe and control instruments to prevent slag crusher produced a load. Should be kept within 2.8 bearings and gearbox have a sufficient amount of lubricating oil, without leakage. 2.9 should pay attention to the bearing operating temperature must not exceed 90 ℃. Single roller slag crusher | Qingdao Xudong electrical equipment (certified) | single roller slag crusher supplied by Power Equipment Co., Ltd. Qingdao Xudong. Power Equipment Co., Ltd. Qingdao Xudong (www.qdxudong.com) (www.qdxudong.com) is a leader in Qingdao, Shandong Province, industry-specific equipment, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, the maximum to meet customer needs. Power Equipment in Qingdao Xudong leadership with the staff warmly welcome all inquiries negotiations to create electrical equipment Qingdao Xudong a better future.