Bucket elevator installation 1, the installation hoist should first fixed base, frame should be fixed on the basis of reliable bucket elevator factory, and then connect to the machine base barrel turn, finally connecting head and mounting geared motors . 2, after the machine installation straightening, barrel across the floor at the floor must be fixed, if attachments should install bearing housing bracket, in order to prevent the entire system tilt and displacement 3 cylinder connection allows pad into the gasket to ensure the seal. 4, hoist the hopper required to install the hopper belt, hopper hopper with good ends were placed from the nose. Bypassing the first round and bottom round, early operation hole to connect. In the apparatus the hopper with time. The bottom should be raised to the highest position of the wheel. 5, the correction to the level of the first axle, axle and trailer axle and head located within a unified vertical plane. 6, bucket elevator for the vertical transportation equipment, first round, bottom round, the center line of the barrel should seek in the same vertical line, the deviation per meter length of not more than 2 mm, no more than 8 mm accumulated deviation. 7, hopper mounted in the elevator, there should be no deviation caused by collision cabinet phenomenon. 8, the hopper belt tensioning device should ensure a uniform work necessary tension. 9, when the hoist is installed scraping bucket elevator, lubricating parts should be filled with oil, no-load test, load test to normal after chain bucket elevator, only for load test and put into production models use As usual lifting equipment, hoist bucket selection subject to many factors, choose the wrong model will bring untold trouble consumers. General decided bucket elevator selection depends on the following factors: 1, form the material: material is powdered or granular or small block. 2, the physical properties of the material: the material is not absorbent or viscosity, is water. 3, the proportion of materials: general bucket elevator parameters are bulk density of the material design and calculation of 1.6 or less, and much of the proportion of material needed traction and transmission parts tensile strength calculations. 4, delivery amount per unit time. The basic requirements 1, hoist shall comply with the requirements of this standard JC460.1 and design drawings and technical documents in accordance with procedures approved by the regulations manufacture, installation and use of this standard, drawings and technical documents unspecified technical requirements, according to building materials machinery, mechanical and electrical industries related to the implementation of common standards .2 not note tolerance dimensions on drawings shall conform to the limit deviation GB 1804, in which machining surface tTl3 level; non-welded machined surface ITl6 level; forging non-machined surface .3 to ITl5 class manufacturing, welding shall comply with the provisions relating to building materials machinery welding .4, gray iron castings shall comply with the provisions of .5 GB 9439 forgings not have a sandwich, folding, crack, satin injury, scarring, slag .6 other defects, hoist should be set level meter, speed monitors and tape anti-deviation means Xudong Qingdao Power Equipment (Figure) |. bucket elevator | bucket elevator is provided by the Qingdao Power Equipment Co., Ltd. Xudong . Qingdao Power Equipment Co., Ltd. Xudong (www.qdxudong.com) (www.qdxudong.com) located at 558 Jiaozhou, Shandong Binzhou Road. Scraps and development in the wave of market economy, the current Qingdao Xudong electrical equipment has a high reputation in the industry-specific equipment, and enjoys a good reputation. Qingdao Xudong electrical equipment made the whole network business alliance certification, marking our service and management level has reached a new height. Qingdao Xudong electrical equipment staff is willing to joint development with all people a better future.